Mobile Robot Control 2023 Group 11

From Control Systems Technology Group
Jump to navigation Jump to search

Group members:

Caption
Name student ID
Anagha Nadig 1830961
Sarthak Shirke 1658581
Idan Grady 1912976

Assignment 1 - Navigation

A* algorithm is more effiient when there are fewer nodes to consider on the map and is faster. In the current map, there are multiple nodes which are adjacent in continuum with each other. This means that the robot can travel long distances without any obstruction. These nodes can be grouped together to form a single node.

The figure below shows the modified node placement of the small maze which can increase the efficiency of the A* algorithm.

Assignment 2 - Navigation

The local path planning algorithm open space method is implemented, to avoid the obstacles detected by the robot while moving. The Laser data obtained when the robot scans the area is used to detect obstacles and determine their position with respect to the robot's frame of reference. The robot is stopped if there is an obstace within a minimum distance from the robot. The area of the open space between the detected obstacles within the field of view of robot is calculated. The heading of the midpoint of the largest open area is obtained and the robot is given a command to rotate towards that heading with the help of odometry data. Then, the robot is asked to move forward with another command. The cycle of scanning, calcualting the open space area, rotating and moving forwad is repeated until it reaches the end of the path.

The simulation result and the video link -

Assignment 3 - Localization

Assignment-1

A program was created which records the odometry data in the current timestep and compares it with the odometry data from the previous timestep. The program is uploaded on the github.

The difference between the current timestep data and the previous timestep data should give the distance the robot has moved.

Assignment-2


Assignment-3

The physical robot was moved and the odometry data was recorded at the current position of the robot. The distance moved by the robot was measired physically using a measuring tape and compared with the odometry data. The table below shows the data

Experiment Measured using Distance moved in 'x' direction (cm) Distance moved in 'y' direction (cm) 'θ' angle rotated (radians)
1 Measuring Tape 278 0 0
Odometry 273 0.62 0.094
2 Measuring Tape 0 135 0
Odometry 0.27 113 0.059
3 Measuring Tape 208 170 0
Odometry 220 139 0.094
4 Measuring Tape 0 0 π
Odometry 0.0005 0.00132 2.09952

The physical robot will have wheelslip which will be recorded by the odometer. The measurement by odometer can be slightly noisy because of physical sensor limitations.

From the experiment it is observed that the odometer does give pretty accurate measurements with slightly large error margin in a few cases and can be used to detect the position of the robot. This dead-reckoning approach

Assignment 4 -Localization