Integration Project Systems and Control 2013 Group 2

Group Members

Name:	Student id:	Email:
Rens Samplonius	0785119	r.j.samplonius@student.tue.nl
Frank Evers	0789890	f.evers@student.tue.nl
Juan Guo	0825223	j.guo@student.tue.nl
Jeroen Lamers	0771264	j.w.lamers@student.tue.nl

Planning

Week 1

- Project planning

- Familiarization with the robot

- Literature searching

- Define specifications of the control system

( This will be the guide for the control system design. As a complete list of requirements can help insure the overall performance and stability of the system. This can avoid the redesign of the controller, when certain important specifications are found to be not satisfied afterwards.One problem of having a complete list of requirements is the trade-off among them, which has to be evaluated based on the importance of the requirement.)

Week 2

- FRF measurement

( Modeling of the system is the first step to its control algorithm design. Two main modeling method we know: physical modeling and data based modeling. Physical modeling is based on conservation law. The system we face is pretty complex and certain phisical phenomina which can have a big influence on the dynamics of the system such as friction is hard to model in this way; also parameters like mass and inertia are not provided directly. Thus we use data based modeling.)

- Familiarization with the robot

- Literature searching

- Define specifications of the control system

Progress

Week 1

1) Literature collecting and background knowledge review.

2) Control system requirement design:

• ...

Week 2

• Rens and Jeroen conducted an FRF measurement on the left pizza robot. They did a closed loop measurement on each axis by applying a sin-wave + white noise to the plant. The sine wave is added to overcome the massive friction. The controller used in the closed loop measurement is tuned very low. During the FRF measurement the following data is collected: the input signal (u), the white noise signal (w), and the output voltages (v). With this data we calculated the process sensitivity and the sensitivity and to obtain the plant we divided them (similar as we did during the Motion Control course). We are uncertain if the left and right pizza robots have a similar plant so perhaps we should repeat the FRF measurement on the right robot because that one has the pizza racks on it.

Week 3

• We decided to use PID controller to control the pizza robot because we all have the most experience with them. This week we evaluated the FRF measurement data and loaded this in the programme ShapeIt. Because the right pizza robot broke we were not able to do more because we scheduled testing time on that robot.

Week 4

• We designed four controllers for each axis with a bandwidth of approx. 10Hz. We also obtaind all the positions to pickup the pizzas. With these positions we start to constuct the optimal trajectory.