Embedded Motion Control 2017 Group 9

From Control Systems Technology Group
Jump to navigation Jump to search

Group Members

Name: Student id:
Mian Wei X
Zhihao Wu X
Petrus Teguh Handoko X
Bo Deng X
Bo Cong X
Jian Wen Kok X
Nico Huebel Tutor


Initial Design

File:Assignment-for-week1.pdf

Requirements

➢ PICO drives autonomously through maze
➢ PICO should find the exit and the whole robot is across the finish line within 5 minutes. ➢ PICO is able to deal with approximately axis‐aligned walls, open spaces and loops in the maze. ➢ The task has to be finished within 2 attempts in 7 minutes. ➢ PICO should not stand still for 30 seconds which counts as an attempt ➢ PICO may not touch the wall ➢ The whole PICO should stop within 1.3m to a dead end, and detect whether the dead end is a door. ➢ PICO should detect every dead it meet ➢ At the exit PICO should drive forward for 40 cm ➢ The software is easy to set‐up

Functions

The software must have the following functions in order to meet the requirements and fulfill the goal:

Function: Description
Drive forward The robot must drive forward unless something, for

example a wall or a corner, is detected

Drive backward The robot must drive a little bit backward if it is unable to rotate
Turn left Make a 90degree left turn
Turn right Make a 90degree right turn
Ring bell The bell must be rang in order to open the door
Localize The robot has to localize itself in the world model, because the

odometry data isn't that accurate

Wait The robot must wait at a dead end in order to check if it is a

door


Components

The following components will be used to reach the goal:

Sensors

  • Laser range finder which uses a laser beam to determine the distance to an object
  • Wheel encoders (odometry) to estimate the position of the robot relative to a starting location

Actuators

  • Holonomic base with omni-wheels
  • Bell to open the door
  • Pan-tilt unit for head (which will not be used)

Computer

  • Intel I7
  • Ubuntu 14.04


Specifications

The goal and the requirements will be achieved with the following specifications:

Robot

  • The maximum transnational speed of the robot is 0.5 m/s
  • The maximum rotational speed equals 1.2 rad/s
  • The corridor challenge has to be solved in 5 minutes
  • The maze challenge has to be solved in 7 minutes
  • Both challenges have a maximum of two trials
  • The laser range finder (LRF) has a range of 270 degrees
  • The wheel encoders have an unknown accuracy
  • The robot must not be idle for more than 30 seconds

Maze

  • The corners will be approximately 90 degrees
  • The wall distance is 0.5-1.5 meter
  • There is only 1 door in the maze
  • The door starts opening in 2 seconds
  • The door opens if the robot is within 1.3 meter of the door
  • The door is open in 5 seconds
  • The number of rings must not be larger than the number of potential doors
  • The maze may contain loops
  • The maze can contain dead ends


Interfaces

Interfaces for Pico/Taco robot in EMC Maze Challenge

The main relations between the interfaces are colored red and can be described as follows:

World model -> Task:The world model can give information about taken paths to the Task
World model -> Skill:The stored observations in the world model are used for movement skills
World model -> Motion:The world model can give data to the actuators
World model -> User interface: The user interface needs the data from the world model to visualize the world model to the human
Task -> World model:The task needs to store information about paths in world model
Skill -> World model :The world model is build from observations
Motion -> World model :The motion can give sensor data about the position to the world model